Hello,

So while the Ring support feature is great for having a great grow it is quite cumbersome to clean prior to casting.

I know the question everyone will be asking is "why don't you just cast and cut off the excess later"
Well I got a one word answer, cost. Basically we pay per gram of casting, and if we were casting a platinum ring that would be an extra expense I can do without.

I've had many cases where my ring would just break under the pressure of cutting away the base, so I opted to find a better alternative.

Below is my iteration of a base support that tries to be an easier breakaway structure, while not compromising the integrity of the structure.

Thoughts of incorporating this into contour?

Please help.
Thanks!

I didn't find the right solution from the Internet.

References:
http://reify-3d.com/forum/viewtopic.php?f=2&t=1021


3d product teaser